Private: Our Products

Browse Products By:
&

709-P3 SeeLeveL II Tank Monitor System

US$269.40

Options

See product descriptions for more information.

Senders

Please select one of the following sender combinations totaling 3 senders for your SeeLeveL RV Gauge system.

6″ sender (710JS)

12″ sender (710ES)

16″ sender (710SS)

Product Overview

The 709-P3 tank monitor is designed for motorhomes and travel trailers with three holding tanks; fresh, grey, and black tank levels.  This model also has a pump switch and monitors battery voltage.

System includes:  1 display monitor, 3 x 12″ 710ES tank senders, and 1 pigtail.

Note:  The standard 12″ 710ES senders may be swapped out for either the 6” 710JS and/or 16” 710SS senders (an additional cost is applied for the 710SS sender).  Select the checkbox above to configure this option.

Precision accuracy – The SeeLeveL II ™ RV tank monitor provides percentage full, accurate tank measurement readouts. These readouts are accurate within 3/8 of an inch.

Simple to install – Two wires connect to your existing system wires and function on a common bus system. Accessible tanks are easy to retrofit.

Reliable external sensors – Our trouble-free senders adhere externally to the holding tanks eliminating sewage build-up on the sensors.

Customize to fit most tanks – The senders are designed to be easily shortened or two can be combined to accommodate almost any holding tank shape or size.  Note:  Will work on most plastic or poly holding tanks that contain any water-soluble products. Will not work on metal tanks.

Service and Warranty – Our professional and knowledgeable technicians are on-call to assist you with any problems you may encounter. Products offer a one-year limited warranty.

Resolution:  710JS sender: ¼” (6 mm), 710ES sender: ⅜” (10 mm), 710SS sender: ½” (13 mm)

Accuracy:  +/- 8% or better, limited by resolution and tank shape.

Operating temperature range:  +32 to +140 °F (0 to + 60 °C)

Sender materials:  0.008” thick glass epoxy circuit board with conformal coating for circuit protection.  Laminated on the back with 3M 300LSE Bonding Adhesive.

Sender length range:  710JS sender: 4” to 6”, which will measure tank heights from 4 ½” to 7”. 710ES sender: 4 ½” to 12”, which will measure tank heights from 5” to 13” (single sender) and up to 25” (dual senders), 710SS sender: 6” to 16”, which will measure tank heights from 7” to 17” (single sender) and up to 34” (dual senders).

Display mounting panel:  Size: 4” wide by 2.8” high (102 mm wide X 71 mm high). Depth varies, 1” – 1 3/8” (25 – 35 mm), model dependent. Panel screws to wa­ll.

System power requirements:  Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts.  Current drain is less than 200mA.

Wiring:  A single two-wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display. LPG wiring: A separate two-wire conductor required from the display to the LPG sender.

Pump:  The pump switch is rated for a maximum of 7.5 amps. The use of a relay is required if more than 7.5 amps are needed. A 7.5 amp (max) fuse must be installed in series with the 12V power circuit to the switch!

RV PRODUCT PURCHASE CURRENCY
USD United States (US) dollar